|
 |
| Innovatek
G-Flow
|
|
The G-flow represents a new
generation of High-end CPU coolers. With its revolutionary flow
guidance, its cooling performance is at the absolute top of water
cooler technology. The G-flow has compact dimensions and an
outstanding design. The base plate consists of nickel plated copper.
The G-Flow represents the pinnacle of design and cooling performance
as engineered by Innovatek in Germany. |
|
Innovatek G-Flow
 |
The G-Flow was developed - like all
innovatek coolers - based on the optimal utilization of the cooling agent
(cooling water). It makes maximum cooling performance using the lowest
flow rates available. The G-flow CPU cooler (like all innovatek coolers)
does not make special demands of pump or cooling system with the flow
resistance of the G-flow being especially minimal. |
Features:
- Highest cooling performance with full metal execution! (completely made
of metal)
- Optimized for modern CPUs
- Minimum pressure loss and No cross-section contraction within the cooler
- Full cooling performance with minimum flow starting from 0.3 l/min.
- Does not need a special pump - minimum flow is enough
- Optimized retaining systems with easy assembly
The special Design of the G-Flow uses optimal thermal capacity of
the cooling agent and makes extreme cooling performance possible.
The interior passage area is not restricted so the flow of the
cooling agent is not obstructed. This contributes to the fact that
the pump is not loaded by a increased flow resistance. |
|
 |
Technical data:
- The weight of the radiator amounts to: approx. 290g
- Base module from pure copper with special nickel layer
- Housing from aluminum (special coating - high gloss)
- Anodized aluminum retaining system |
 |
Included:
- Cooler completely installs with integrated base system
- CoolLaboratory liquid PRO thermal compound
- Additionally: Standard thermal compound single use pack
- Assembly instructions
- The cooler with 8x1 compression fittings attached (straight - with
rubber O ring seal) (Included fittings are G1/4" thread 8mm
interior/10mm outside diameter tubing)
- Note that the G-Flows require the use of the screws that come with your
motherboard for attachment. |
Note: Only use distilled water in connection with
InnovaProtect (sold
separately) as cooling agent!! Absolutely avoid the contact of the
cooler with methanol, ethanol or alcohol - This could damage the cooler
irreparably!!
|
|
